Saeco TALEA - Electronics; Boiler Pin

Saeco International Group Page 3 / 13
TALEA / ODEA - LINE 07 DISASSEMBLY
To disassemble the boiler’s pin
To disassemble the power board
Fig. 1
• Remove the black board’s cover.
• Loosen the plug contact.
• Remove the screws shown.
1
7.3. Electronics
7.4. Boiler’s pin
21
3
Fig. 1
• Remove the screws shown.
• Remove the water channel cover.
Fig. 2
• Remove the screws (4 off) shown.
Fig. 3
• During assembly, both screws have
to be tightened alternately at equal
rates to prevent the O-rings from being
squeezed.
To disassemble the control board
Fig. 1
• Remove the screws shown.
• Fold the board to the back.
Fig. 2
• Loosen the plug contact.
Fig. 3
• Remove the screws shown.
1 2
3