Sam4s ER-5200M Service Manual

8 Troubleshooting
8-2 SAM4S ER-5200 Series
8-2 System Problem
End
System Problem
Reset Signal
Ok?
Y
N
1. Check the IC M51953B(U13)
2. Check the 74HC14(U17).
3. Check the RST Pattern on PCB.
Power Fail
Si
g
nal Ok?
Program
Ok?
Y
1. Check the nCS, nRD signal of Flash ROM
2. Check the Addr/Data line Pattern whether it is short.
3. Download the PGM File in Flash ROM through RS-232
Cable.
4. Replace the Flash ROM
1. Check the LM393(U22)
2. Check the Power (+24V,+5V)
3. Check the related Circuit and Pattern on PWB
N
N
SRAM Ok?
Y
Y
N
CPU
Ok?
Y
N
1. Check the nCS, nRD, nWR signal of SRAM
2. Check the VBT(Battery Volt.).
3. Check the Decoder IC 74HC138 (U24).
4. Re
p
lace the SRAM.
Y
N
1. Check the Clock (14.7456MHz)
2. Check the Power of CPU VCC Pin (+5V)
3. Check the mounted state of CPU pin whether the pin is
open or short
RTC Ok?
1. Check the nCS, nRD, nWR signal of RTC
2. Check the VBT(Battery Volt.).
3. Check the Decoder IC 74HC138 (U24).
4. Check the RTC Clock 32.768KHz
5. Re
p
lace the RTC
(
RF5C15
)

Sam4s ER-5200M Specifications

General

Brand	Sam4s
Model	ER-5200M
Category	Cash Register
Language	English