Sam4s ER-5215M - Program 300 - PLU Descriptor Programming

ER-5215M Electronic Cash Register v2.23 P-Mode Programming • 103
Program 300 - PLU Descriptor Programming
Note: You can program descriptors up to 18 characters, however only the first 16 will appear
on the display.
1. Turn the control lock to the P position
2. To begin the program, enter 3 0 0, press the SBTL key.
3. Select the PLU you wish to program in one of the following ways:
 Press a PLU key on the keyboard or scan the item.
 Enter the number of the PLU and press the PLU key.
4. Enter up to 18 three-character codes and press the X/TIME key. (See “Descriptor Code
Chart” on page 104.)
5. To program additional PLUs, repeat from step 3, or press the CASH key to finalize the
program.
3 0 0 SBTL
PLU
PLU
CASH
X/TIME
Enter up to 18 three-
character codes