162 • P-Mode Programming ER-5215M Electronic Cash Register v2.23
Program 1600 - Machine Number Programming
The machine number is printed on the register receipt. Program a machine number so that any receipt
or journal can be identified with the store or register where the transaction took place.
Programming the Machine Number
1. Turn the control lock to the P position.
2. To begin the program, enter 1 6 0 0, press the SBTL key.
3. Enter a machine number (up to 5 digits); press the X/TIME key.
4. Press the CASH key to finalize the program.
Program 1900 – Starting Kitchen Printer Order Number
When using a kitchen printer or requisistion receipt, you can program the starting order number that
will appear on the requisition. When a Z1 financial report is taken, the requisition number will reset
and begin again at the number set here. (This feature is available in software version 5.4 or later.)
Programming the Starting KP Order Number
1. Turn the control lock to the P position.
2. To begin the program, enter 1 9 0 0, press the SBTL key.
3. Enter the starting number (up to 4 digits); press the X/TIME key.
4. Press the CASH key to finalize the program.
6 0 0 SBTL 1
CASH
X/TIME
9 0 0 SBTL 1
CASH
CASH
X/TIME
To Next Page
Loading...
