Sam4s ER-5215M - Group Programming

148 • P-Mode Programming ER-5215M Electronic Cash Register v2.23
Group Programming
20 Group totals are available to accumulate totals of individual PLUs that are assigned to each group.
Each PLU can be assigned to one, two or three different groups. (See “Program 150 - PLU Group
Assignment” on page 100 to program PLU groups for each PLU.)
 Use program 900 to assign a group status, i.e. a group can be set to not add to the total of
all groups, or a group can be used to designate like items for kitchen printer assignment.
 Use program 910 to assign a unique descriptor for each group, so that the group may be
easily understood on the group report.
Programming Group Status - Program 900
1. Turn the control lock to the P position.
2. To begin the program, enter 9 0 0, press the SBTL key.
3. Enter the number (1-99) of the group you wish to program; press the X/TIME key.
4. Enter an option digit from the table below, press the SBTL key.
Address OPT ION VA LUE = SUM
Group total is added to the total of all
groups on the Group report?
Yes = 0
No = 1
N1
Send to kitchen printer?
Yes = 2
No = 0
No Choice 0
KP PORT# : R(requisition on the register
receipt)
1
KP PORT#: 1 2
N2
KP PORT#: 2 4
N3
Print RED on KP?
Yes = 1
No = 0
N4
Gift Card:
None = 0
Activate = 1
Add = 2
5. To program additional groups, repeat from step 3, or press the CASH key to finalize the
program.
9 0 0 SBTL
X/TIME
CASH
N2 N3 N4 SBTL N1