Sam4s ER-5215M - Memory Allocation Program

80 • S-Mode Programming ER-5215M Electronic Cash Register v2.23
Memory Calculation Example
Note: Default memory allocation varies by version. The example below is for v7.5 software. Other
versions may have different default allocations.
Variable Bytes per
unit
Default
Quantity
Total
PLU 78 1000 78,000
Clerks 1705 10 17,050
Groups 47 15 705
Guest Check 494 10 4940
Lines per Soft Check 38 10 x 30
(guest check
quantity)
11,400
Mix & Match 20 20 400
Total Used 121,235
Total Available varies
Memory Allocation Program
Once you have determined the memory variable you wish to set, you can set them in the memory
allocation program. If you attempt to allocate more options than memory, the message “MEMORY
ALLOCATION SIZE OVER” will print on the receipt and journal.
1. Turn the control lock to the S position.
2. To Allocate Memory, enter 6 0 and press the SBTL key.
3. Refer to the chart below and enter a digit to represent allocated area and press the
X/TIME key.
4. Enter the desired allocation.
Note for the CHECK TYPE
entry: enter 0 for soft check
or enter 1 for hard check.
5. Repeat from step 3 to allocate another area, or press the CASH key to finalize the
program. If the allocation is accepted, the printer will print the new allocation. If the
allocation is not accepted, the message “ALLOCATION OVER . . .” will display.
X Allocated Area
1
PLU
2
CLERK
3
GROUP
4
CHECK#
5
SOFT CHECK LINES
6
CHECK TYPE : Hard(1), Soft(0)
7
MIX & MATCH
The total memory
used must be less that
the total memory
available
CASH
0
SBTL 6
CASH
X X/TIME