154 • P-Mode Programming ER-5215M Electronic Cash Register v2.23
Program 710 - Clerk Report Descriptor Programming
The Clerk Report selection allows you to reprogram the descriptors that appear with the Clerk Report
totals and counters. For example, the first total on the clerk report "NET SALES" might be re-labeled
to say "GROSS SALES". You can reprogram any of the Financial Report totals listed here with any
12-character descriptor.
1. Turn the control lock to the P position.
2. To begin the program, enter 7 1 0, press the SBTL key.
3. Refer to the chart on the next page and enter the number that represents the line you wish
to program; press the X/TIME key.
4. Enter up to 18 three-character codes and press the X/TIME key. (See “Descriptor Code
Chart” on page 104.)
5. Press the CASH key to finalize the program.
7 1 0 SBTL
X
X/TIME X
CASH
SBTL
Enter up to 18 three-
character codes
To Next Page
Loading...
