Sam4s ER-5215M - Program 1100 - Cash-In-Drawer Limit Programming; Program 1200 - Check Change Limit Programming

ER-5215M Electronic Cash Register v2.23 P-Mode Programming • 159
Program 1100 - Cash-In-Drawer Limit Programming
You can set a cash-in-drawer limit. When cash in drawer exceeds the limit a warning will display on
the screen. You must press CLEAR to remove the warning and continue operations. The warning will
continue to appear at the completion of every transaction with the limit exceeded, until you use the
PAID OUT function to remove cash from the drawer.
Programming the Drawer Limit
1. Turn the control lock to the P position.
2. To begin the program, enter 1 1 0 0, press the SBTL key.
3. Enter a cash-in-drawer limit (up to 8 digits or 0 for no limit); press the X/TIME key.
4. Press the CASH key to finalize the program.
Program 1200 - Check Change Limit Programming
Use this program to set the maximum amount of cash that can be returned when a check is tendered
for an amount greater than the amount of the sale. For example, if the check change limit is $10.00 the
maximum amount that can be tendered into the check key on a $5.00 sale is $15.00.
Programming the Check Change Limit
1. Turn the control lock to the P position.
2. To begin the program, enter 1 2 0 0, press the SBTL key.
3. Enter a cash-in-drawer limit (up to 8 digits or 0 for no limit); press the X/TIME key.
4. Press the CASH key to finalize the program.
1 0 0 SBTL 1
CASH
X/TIME
Enter the cash
limit, up to 8
digits
2 0 0 SBTL 1
CASH
X/TIME
Enter the cash
limit, up to 8
digits