Samson 3374-11 - Page 99

Index
EB 8331-4 EN 99
N
Nameplate .......................................... 11
O
Operating controls
Display .......................................... 36
Menu control .................................. 38
Rotary pushbutton ........................... 38
Serial interface ............................... 39
Operating direction .............................. 52
Operating level .............................. 42, 82
Operating mode .................................. 42
Operation ............................................ 36
P
Parameters........................................... 82
Plausibility error ................................... 64
Positioner ............................................. 45
Position feedback signal ........................ 54
Principle of operation ........................... 12
Priority position .............................. 55, 56
R
Removal .............................................. 79
Restart ................................................. 57
Rotary pushbutton ................................ 38
S
Safety instructions............................. 6–10
Serial interface ..................................... 39
Service ................................................ 81
Service level ................................... 67, 89
Servicing ............................................. 75
Speed level .......................................... 59
Start screen .......................................... 36
Start-up ............................................... 23
Storage ............................................... 22
Switching range ................................... 59
T
Technical data ................................ 16–19
Temperature control .............................. 47
Terminal assignment ............................. 47
Testing according to DINEN14597 ...... 12
Three-step mode ................................... 46
Transit time .................................... 59, 70
Transporting ........................................ 22
Two-step mode ..................................... 46
Z
Zero calibration ............................. 57, 68