Samson 373 Series User Manual

44 EB 8384-2 EN
Mounting and start-up
If a pin position other than position 35 with
the standard M lever is required or an L or
XL lever size is required, proceed as follows
(seeFig.5):
1. Fasten the follower pin (2) in the as-
signed lever hole (pin position as speci-
edinthetraveltablesonpage28).
Only use the longer follower pin included
in the mounting kit.
2. Place the lever (1) on the shaft of the po-
sitioner and fasten it tight using the disk
spring (1.2) and nut (1.1).

Samson 373 Series Specifications

General

Brand	Samson
Model	373 Series
Category	Valve Positioners
Language	English