To Next Page

To Previous Page

76 EB 8384-2 EN

Mounting and start-up

5.10.3 Mounting the position

sensor to Type3510

Micro-ow Valve

Î Requiredmountingpartsandaccesso-

ries:Table8onpage27.

Î RefertoFig.28

1. Place the lever (1) on the position sen-

sor in mid-position and hold it in place.

Unscrew the nut (1.1) and remove the

standard attached M lever (1) together

with the disk spring (1.2) from the sen-

sor shaft.

2. Screw the position sensor (20) onto the

bracket (21).

3. Select the S lever (1) from the accessories

and screw the follower pin (2) into the

hole for pin position 17. Place the lever

(1) and disk spring (1.2) on the sensor

shaft. Place the lever in mid-position and

hold it in place. Screw on the nut (1.1).

4. Place follower clamp (3) on the valve

stem connector, align at a right angle

and screw tight.

5. Position the bracket (21) with the position

sensor on the valve yoke and screw tight,

making sure the follower pin (2) slides

into the groove of the follower clamp (3).

20 21

1.1

1.2

1 Lever

1.1 Nut

1.2 Disk spring

2 Follower pin

3 Follower clamp

20 Position sensor

21 Bracket

Fig.28: Mounting on a micro-ow valve

Samson 373 Series User Manual

Other manuals for Samson 373 Series