Samson 3730 Series - Page 109

EB 8389-1S EN 109
Appendix
Parameters
Reset Code 36
Diag Std DS
Start-up > Reference graphs > Valve signature
Sensitivity YES YES YES
Start-up > Reference graphs > Leakage sensor > Manufacturer reference
Settling time before sound level measurement NO NO NO
Sensitivity sound level NO NO YES
Set points NO NO YES
Start-up > Reference graphs > Leakage sensor > Process reference
Settling time before sound level measurement NO NO NO
Sensitivity sound level NO NO YES
Response time NO NO YES
Preset alarm limits NO NO YES
Alarm limits 1 to 3 NO NO YES
Set points NO NO YES
Device settings > Positioner
Attachment NO NO YES
Inductive limit switch (Code 38) NO NO NO
Device settings > Positioner > Transfer characteristic
Direction of action (Code 7) NO YES YES
Lower set point range value (Code 12) NO YES YES
Upper set point range value (Code 13) NO YES YES
Activate CLOSED end position (Code 14) NO YES YES
CLOSED end position (Code 14) NO YES YES
Activate OPEN end position (Code 15) NO YES YES
OPEN end position (Code 15) NO YES YES
Enter transit time OPEN (Code 21) NO YES YES
Enter transit time CLOSED (Code 22) NO YES YES
Lower travel/angle range value NO YES YES
Appendix