Samson 3730 Series - Page 110

110 EB 8389-1S EN
Appendix
Parameters
Reset Code 36
Diag Std DS
Upper travel/angle range value (Code 9) NO YES YES
Activate lower travel/angle limit (Code 10) NO YES YES
Lower travel/angle limit (Code 10) NO YES YES
Activate upper limit for travel/angle (Code 11) NO YES YES
Upper limit for travel/angle (Code 11) NO YES YES
Select characteristic (Code 20) NO YES YES
User-dened characteristic NO YES YES
Device settings > Positioner > Transfer characteristic on/off
Activate CLOSED end position (Code 14) NO The type of application
is reset to 'On/off
valve'.
The Transfer
characteristic on/off
folder is not displayed
after resetting.
Parameters of the
Transfer characteristic
on/off folder are reset
to their default settings.
CLOSED end position (Code 14) NO
Activate OPEN end position (Code 15) NO
OPEN end position (Code 15) NO
Enter transit time OPEN (Code 21) NO
Enter transit time CLOSED (Code 22) NO
Operating point (Code 49 - h1) NO
Fail-safe action limit (Code 49 - h2) NO
Operating point limit (Code 49 - h5) NO
Device settings > Positioner > HART communication
Bus address (Code 46) NO NO YES
Enter no. of preambles NO NO YES
Primary variable assignment NO NO YES
Secondary variable assignment NO NO YES
Tertiary variable assignment NO NO YES
Quaternary variable assignment NO NO YES
HART® write protection NO NO YES
Device settings > Valve
Valve manufacturer NO NO YES
Actuator motion NO NO YES
Appendix