SANY SY16C - Hydraulic Lockout Control Lever

SY16C Excavator OMM Machine Controls
SANY Operation and Maintenance Manual — 0420 3-5
TABLE OF
CONTENTS
INTRODUCTIONSAFETY
MACHINE
CONTROLS
MACHINE
OPERATION
MAINTENANCESPECIFICATIONS
OPTIONAL
EQUIPMENT
Hydraulic Lockout Control Lever
The hydraulic lockout control lever disables or enables the
controls for work equipment, swing, travel, and
attachments (if equipped) to prevent accidental movement.
• Pull the hydraulic lockout control lever to the
locked (closed) (1) position to disable some
hydraulic controls.
NOTE: The boom swing pedal, optional equipment
pedal, and the dozer blade control are not
disabled when the hydraulic lockout control
lever is engaged.
WARNING!
• Always place the hydraulic lockout control lever in the locked (closed) position before
leaving the operator seat.
• The boom swing pedal, optional equipment pedal, and the dozer blade control are not
disabled when the hydraulic lockout control lever is engaged. Make sure covers are in
place over the pedals when not in use, and avoid unintentional movement of the dozer
blade control while the engine is running.
Failure to follow this warning, and unintended movement of the joysticks or travel control
levers/pedals, could result in death or serious injury.
NOTICE!
If any part of the machine moves (except boom swing pedal, optional equipment pedal, and
dozer blade control) when the hydraulic lockout control lever is in the locked (closed)
position, shut down the engine immediately. Contact a SANY dealer to solve this problem.
Fig. 3-3
0004987
1