Basic Operations (Continued)
Channel Selection
Digital sub-channels
A digital TV signal transmits more data than an analog signal. This ncrease in data provides a better picture and sound
with less static and interference.
The increased data capacity of a digital signal also lets broadcasters fit several channels into the same bandwidth as an
analog signal. Broadcasters may use these sub-channels to transmit a variety of information, such as weather forecasts,
foreign languages, commercials.
A digital sub-channel is indicated by the main channel number followed by a dot and the sub-channel number. For
example, 5.1 indicates sub channel 1 of the main channel 5.
i
You can use the following ways to change channels:
! Press CH or CH to go to the next or previous channel in the memorized channel list.
! To select an analog channel, press the number buttons for the channel you want, then wait for the channel to change or
press ENTER to immediately change the channel.
! To select a main digital channel, press the number buttons for the main channel, then wait for the channel to change or
press ENTER to immediately change the channel.
! To select a digital sub-channel, press the number buttons for the main channel, press the dot(.) , then press the number
button for the sub channel. Wait for the channel to change, or press ENTER to immediately change the channel.
Note: Button presses must be within three seconds of each other.
! To go to the last channel viewed, press RECALL.
! To select a channel from the memorized channel list, press CH-LIST, press 5 or 6 to select the channel, then press
ENTER.
! To select a favorite channel from the favorite list, press FAVORITE, press 5 or 6 to select the channel, then press
ENTER.
Note: If the list has more than one page, press 3or4to scroll through the pages.
18
! Press MENU to call up the OSD main menu.
– The screen will now display Picture menu.
! Press 3or4 one or more times to select menu, press 6to access.
– Picture, Audio, Setup, Channel menu can be selected.
! From the menu, press5634to navigate or adjust. Press ENTER to
confirm an entry or selection.
! To return to previous menu, press MENU.
! To close the menu, press EXIT.
To operate the OSD (on-screen display) menu:
Using the OSD menu
To Next Page
Loading...
