Sanyo PLC-HP7000L - INPUT 3 Command; NETWORK Command; VIDEO MUTE on Command; VIDEO MUTE off Command

PLC-HP7000L Basic Serial Command Functional Specifications
13/27
6.10 INPUT 3 Command
Command “C07” [CR]
Detail
Select Input 3. This command works differently from the command by “Input 3”
key of the remote control. When Input 3 has been selected, this command does
not execute the source switching; just for switching to Input 3.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.11 NETWORK Command
Command “C08” [CR]
Detail
Select Network Input.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.12 VIDEO MUTE ON Command
Command “C0D” [CR]
Detail
Video Mute ON
This command works the same way as “SHUTTER” button of the remote control
for Shutter Close, but does not work for Shutter Open.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.13 VIDEO MUTE OFF Command
Command “C0E” [CR]
Detail
Video Mute OFF
This command works the same way as “SHUTTER” button of remote control for
Shutter Open, but does not work for Shutter Close.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.14 SCREEN NORMAL SIZE Command
Command “C0F” [CR]
Detail Set screen size to Normal (4:3)
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.15 SCREEN FULL SIZE Command
Command “C10” [CR]
Detail Set screen size to Full.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]