Sanyo PLC-HP7000L - PRESENTATION TIMER (Exit) Command; KEYSTONE ↑ Command

PLC-HP7000L Basic Serial Command Functional Specifications
21/27
6.58 PRESENTATION TIMER (Exit) Command
Command “C8B” [CR]
Detail
Exit P-Timer function.
This command works the same way as pressing and hold “P-TIMER” button of the
remote control.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.59 KEYSTONE ↑ Command
Command “C8E” [CR]
Detail
Correct keystone distortion by reducing upper part of image. This command
invokes both operations of keystone distortion correction and OSD display,
regardless of whether the “KEYSTONE” OSD has been already displayed or not.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.60 KEYSTONE ↓ Command
Command “C8F” [CR]
Detail
Correct keystone distortion by reducing lower part of image. This command
invokes both operations of keystone distortion correction and OSD display,
regardless of whether the “KEYSTONE” OSD has been already displayed or not.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.61 KEYSTONE → Command
Command “C90” [CR]
Detail
Correct keystone distortion by reducing right side of image. This command
invokes both operations of keystone distortion correction and OSD display,
regardless of whether the “KEYSTONE” OSD has been already displayed or not.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.62 KEYSTONE ← Command
Command “C91” [CR]
Detail
Correct keystone distortion by reducing left side of image. This command
invokes both operations of keystone distortion correction and OSD display,
regardless of whether the “KEYSTONE” OSD has been already displayed or not.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]