Sanyo PLC-HP7000L - FOCUS - Command; INPUT 1 HDMI Command; INPUT 1 ANALOG RGB Command; INPUT 1 SCART Command

PLC-HP7000L Basic Serial Command Functional Specifications
19/27
6.46 FOCUS - Command
Command “C4A” [CR]
Detail
Adjust on-screen focus by making focal length shorter. (The lens moves forward)
This command works the same way as “FOCUS ▼” button of the remote control.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.47 INPUT 1 HDMI Command
Command “C4F” [CR]
Detail
Select HDMI input in Input 1.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.48 INPUT 1 ANALOG RGB Command
Command “C50” [CR]
Detail
Select Analog RGB input in Input 1.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.49 INPUT 1 SCART Command
Command “C51” [CR]
Detail
Select SCART input in Input 1.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.50 INPUT 1 DVI (PC DIGITAL) Command
Command “C52” [CR]
Detail
Select DVI (PC Digital) input in Input 1.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.51 INPUT 1 DVI (AV HDCP) Command
Command “C53” [CR]
Detail
Select DVI (AV HDCP) input of Input 1.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Response Acceptable [ACK] [CR]