Sanyo PLC-HP7000L - INPUT 2 Y,Pb;Cb,Pr;Cr Command; INPUT 2 RGB Command; IMAGE Command; Direct on SET Command

PLC-HP7000L Basic Serial Command Functional Specifications
15/27
6.22 INPUT 2 Y,Pb/Cb,Pr/Cr Command
Command “C24” [CR]
Detail
Select Y,Pb/Cb,Pr/Cr input in Input 2.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.23 INPUT 2 RGB Command
Command “C25” [CR]
Detail
Select RGB input in Input 2.
Although projector returns “OK”, Input search is not executed with this command
while Input button is set to Mode2 or Mode3.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.24 IMAGE Command
Command “C27” [CR]
Detail Switch Image Setting status
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.25 Direct on SET Command
Command “C28” [CR]
Detail
Enable Direct on
This status is stored in EEPROM and retained regardless of Power OFF/ON
operation.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.26 Direct on CANCEL Command
Command “C29” [CR]
Detail
Disable Direct on
This status is stored in EEPROM and retained regardless of Power OFF/ON
operation.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.27 POWER MANAGEMENT READY1 Command
Command “C2A” [CR]
Detail
Set Power Management function to ready1 status
This status is stored in EEPROM and retained regardless of Power OFF/ON
operation.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]