Sanyo PLC-XF60A - Integrator-in Angle Adjustment

- 33 -
Optical Adjustment
Blue band Yellow bandBlue band
Yellow band
z Integrator-in angle adjustment
Condition: Lamp 2 Mode
(Menu: Setting -> Lamp -> Mode -> 1-Lamp -> Lamp 2)
1 Remove a shutter assy from the optical unit and disconnect the FPC
cables of the panels.
2 Turn the projector on with Lamp 2 mode.
3 Loosen 2 screws A and on the integrator-out and 2 screws C on the
integrator-in (Fig1-1 and Fig1-2).
4 Insert a slot screwdriver into the slot-B on the integrator-out and dis-
play the color band on the top and bottom of the screen by turning
the screwdriver as shown in Fig,1-1.
5 Insert a slot screwdriver into the slot-D on the integrator-in and dis-
play the color band on the left and right of the screen by turning the
screwdriver as shown in Fig,1-2.
6 Tempolarily tighten screws C and loosen 2 screws E on the Integra-
tor-in and turn the Integrator-in left or right by usind the shadow part
of the holder until the edge of the color band becomes clearest.
7 Tightem screws A, C and E to fix the Integrator-in and out unit.
Eddge becomes clear
Blue band
Yellow band
Fig.1-1
Fig.1-2
(Target screen image)
A
B
A
E
E
C
D
C
Integraror-In
Integraror-Out