EasyManua.ls Logo

Sanyo SPW-CR703GDCH8 - Page 290

Sanyo SPW-CR703GDCH8
377 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Test Run and Others
5
TD831077
V-7
1. Test Run
LED (red)
Alarm message
87654321
H01 ●●●●●●O
H02 ●●●●●O
H03 O ●●●●●OO
F27 OOOO OO
H09 O ●●●O ●●O
H11 O ●●●O OO
H12 O ●●●OO●●
H13 O ●●●OO O
F28 OOOOO●●
H19 O ●●O ●●OO
H21 O ●●O O O
H22 O ●●O OO
H23 O ●●O OOO
F21 OOO O O
H29 O ●●OOO O
H08 O ●●●O ●●●
H28 O ●●OOO●●
H07 O ●●●●OOO
L17 OO O ●●●O
Remote
controller
display
Overload current
Lock current
Current is not detected when compressor is ON
Current is detected when compressor is OFF
MG SW is chattering
Overload current
Lock current
Current is not detected when compressor is ON
Current is detected when compressor is OFF
MG SW is chattering
Overload current
Lock current
Current is not detected when compressor is ON
Current is detected when compressor is OFF
MG SW is chattering
PC comp.
SC comp.
Mis-matching setting of refrigerant kinds between
CCU and outdoor P.C.B.
NOTE
: Alarm display LED lamps may all be lit up or all blink at once.
(Without: light up all at once only)
CCU : Command control unit (incorporated in outdoor unit)
PC unit : Power control unit
AD unit : Additional unit
PC comp. : Power control compressor
AC comp. : Constant speed compressor
SC comp. : Scroll compressor
PC comp. CT detection current
AC comp. CT detection current
SC comp. CT detection current
Oil sensor fault
Low oil level
Improper setting

Table of Contents

Related product manuals