Sanyo SPW-CR703GDCH8 User Manual

Control of W-ECO MULTI SYSTEM
3
TD831077
III - 24
2. Optional Controller (remote controller)
(H) Change the shift temperature in heating mode
❏ If the indoor unit is installed at high location (ex. ceiling level), the thermostat tends to turn off early in heating
mode because of the hot air temperature of ceiling level. In order to resolve the problem, the shift temp. (valid
while heating only) is set when shipped from factory (refer to room temp. control P. III-2).
❏ If the shift temp. is not enough (ex. the indoor unit is installed at position higher than 3 m), the shift temp. can
be set with remote controller from +1 to +10 deg manually as follows:
a Press the TEST / CHK button for more than 4 seconds.
e Press the SET button.
CODE No. 06, SET DATA and
SETTING
change from flashing to ON state.
f If you make mistake, press the CL button.
g Finally, press the TEST / CHK button.
b In case of group control, if you want to change all units in group control collectively, proceed next step remaining
ALL displayed.
If you want to change a unit individually, select the indoor unit address (UNIT No.) with UNIT button.
c Select the CODE No. 06 with
, (SET TEMP) button.
d Choose the shift temp with , ( ) button.
EX:
UNIT No. 1–6
CODE No. 06
Shift temp. +5 deg
SET CL
MODE
FAN SPEED
ON
OFF
•
•
SET TEMP.
UNIT
FLAP
AIR FLOW
R.C. No.
SET
UNIT No.
No.CODE
TIMER SET
DATA
SETTING
TEST / CHK
837_8132
SET CL
MODE
FAN SPEED
ON
OFF
•
•
SET TEMP.
UNIT
FLAP
AIR FLOW
R.C. No.
SET
UNIT No.
No.CODE
SET TEMP.
TIMER SET
DATA
SETTING
TEST / CHK
838_8132

Sanyo SPW-CR703GDCH8 Specifications

General

Brand	Sanyo
Model	SPW-CR703GDCH8
Category	Air Conditioner
Language	English