Sanyo SPW-CR703GDCH8 - Optional Controller; List of Optional Controller Functions; Remote Controller

Control of W-ECO MULTI SYSTEM
3
TD831077
III - 5
2. Optional Controller
Function
7 List of optional controller functions
¶ Remote controller functions
In multi system, the following optional remote controllers can be selected, but there are some functions which cannot be
controlled. So, confirm the usable functions from the following table at the time of selecting them.
j: Controllable ✕ : Uncontrollable
Operation mode switch
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
NOTE
Setting
range
System
NOTE
If you use both remote controller and system controller concurrently, both controller can be used on a last-signal priority
basis.
Remote System Simplified Remote
Controller Controller Controller
RCS-SH80TG SHA-KC64TG RCS-KR1TG
ON / OFF jj (Collective/Individual) j (Collective/Individual)
Heating jj (Individual) j (Individual)
Dry jj (Individual) j (Individual)
Cooling jj (Individual) j (Individual)
Fan jj (Individual) j (Individual)
Temp setting jj (Individual) j (Individual)
Fan speed setting (H / Me / L / auto) jj (Individual) j
Auto flap Auto airflow direction setting jj✕
Arbitrary airflow direction setting j *2 j ✕
Sweep (Flap swing) j *2 jj
72 hr ON / OFF timer j ✕✕
Sensor temp display j ✕✕
Self-diagnostic function (as sub controller) * 3 jj ✕
Cummulative operation time * 3 ✕✕✕
Central control (at hand inhibited) ✕ j ✕
Group control j (Up to 8 units) j (Up to 16 groups) j
Multiple units set in parallel ( as sub controller ) *1 jjj
Multiple units set in parallel (as main controller) jjj
Concurrent use as weekly timer jj ✕
Cooling, dry ( °C) 18 ~ 30 18 ~ 30
Heating ( °C) 16 ~ 26 16 ~ 26
* 1 To use as a sub controller, the address switch of its remote control PCB must be set (from OFF to ON.).
* 2 This function is not useable for indoor unit which is connected remote controller.
* 3 This function is to estimate the simple electrical charge.