A: Please adjust the circular-frame around the Webcam’s Len, until the image from
Webcam showed on PC’s screen is clear.
3. Q: Can I use two Webcams at the same time?
A: No, N+ 3.5G Mini Server Router supports only one Webcam to monitor.
4. Q: Can I use any digital camera which supports webcam function to connect
to N+ 3.5G Mini Server Router?
A: No, N+ 3.5G Mini Server Router doesn’t support digital camera.
5. Q: Does N+ 3.5G Mini Server Router support all Webcam models?
A: No, N+ 3.5G Mini Server Router only supports the Webcams possessing OV511,
OV511+, SAA8115HL, Sonix PcCam, Sonix PcCam+, Sonix sn9c102P
Hv7131R, Sonix sn9c120 OV7648, Generic spca536a, Z-star Vimicro 0301p,
Z-star Vimicro Zc0302 or SAA8116HL chipsets. To make sure Webcam is
supported, please check on our Webcam support list for your reference.
6. Q: Why couldn’t the image of USB Webcam be seen from WAN?
A: Besides making sure to enable the USB Webcam Access from WAN, the
Remote Management should be enabled as well, so that the image of USB
Webcam could be seen from WAN.
9.10 Printer Server
1. Q: Why can’t my printer work?
A: For more details, please refer to Chapter 3.5.5 Print Server in the USB
Application. Maybe N+ 3.5G Mini Server Router doesn’t support your printer.
You can contact with us to get more updated information about printer driver
support.
2. Q: Printer is beginning printing, but it prints slowly and with unidentified
words or codes. How could it happen?
A: Your printer’s driver is lost or incompatible with your router. Please set up the
printer’s driver again. If you don’t have the appropriate driver or want to get a
compatible one, please contact with your printer supplier.
To Next Page
