4.2.3.3 WAN Interface– Wireless
If you are connecting the internet via wireless, please select Wireless and its associated
settings will show up underneath at the same time.
You can see a list of available Wireless networks. Select you preferred one to connect
and the Encryption type form the drop-down list.
4.2.3.4 WAN Access Type – Static IP
Choose Static IP Address if all WAN IP information is provided to you by your ISP. You will
need to enter the IP address, IP Netmask and IP gateway as provided. Each entered
fields must be in the appropriate IP form, which are four IP octets separated by a dot
(x.x.x.x). The Router will not accept the IP address if it is not in this format. Fill in the DNS
information provided by your ISP; otherwise, Domain Name can’t be used.
In particular, here provides 3G or 3.5G transmission rate when the 3.5G adapter is
plugged, just check to apply for the backup. In other words, once Static IP connection is
disconnected, the system automatically connects Internet via 3.5G adapter. If 3.5G signal
is not available, it starts to search downward for 3/2.75/2.5G signals until none existed.
The default interval between the two connection detection is 3 minutes. The interval
To Next Page
Loading...
