Bench Mounting
Warning!
Severe electrical shock hazard
or danger of electrocution!
Do not place arium 611VF on top
of electrical equipment. Water may
spill when using the system.
Warning!
Danger of fire or explosion!
Do not use in the presence of
flammable or combustible materi-
als; fire or explosion may result.
The device contains components
which may ignite such materials.
• Place the arium 611VF on a flat
surface.
• Ensure that feed water and a
100-240 V electric socket are
accessible.
Note
The outlet of a gravity feed storage
reservoir must be at least 10 cm
higher than the inlet of the arium
611VF.
11
Wall Mounting
Caution!
Wall composition, condition and
construction, as well as fastener
type must be considered when
mounting this unit. The mounting
surface and fasteners selected
must be capable of supporting
a minimum of 25 kg. Inadequate
support and|or fasteners may
result in injury to the operator
and|or damage to the equipment.
A wall bracket (2) is included in the
shipment to enable you to attach
the system securely to the wall so
that it occupies a minimum amount
of space. A clear wall area of
63 + 63 cm is required to mount
the arium system. Two sturdy
keyhole drill holes (1) are located at
the top of the back of the housing
enabling you to hang the unit on
the two pins (5) on the wall bracket.
Use the predrilled holes in the
bracket to fasten the bracket to
the wall. The lower metal profile (6)
on the arium housing functions as
a spacer.
• Ensure that water, a 100 - 240 V
electric socket and an atmospheri-
cally vented drain are accessible.
• Fasten the bracket to the wall with
suitable screws and dowels.
• Lower the keyhole drill holes of the
arium 611VF onto the two pins on
the wall bracket.
• Tighten the screw (3) of the metal
support (4) on the right side of
the bracket with a screwdriver until
the metal support rests against the
arium housing.
!
!
!
1
2
3
4
5
6
Lower the arium housing onto the wall-mounting bracket
To Next Page
Loading...
