Sartorius arium 611VF - Control Panel and Display Functionality

Control Panel and Display
Operate arium 611VF using the
control panel that incorporates four
function keys and two control keys
for the cursor.
STANDBY Key
Press the Standby key to place
the unit into Standby Mode. In
this mode the water in the system
is recirculated for 15 minutes
per hour.
OPERATE|STOP Key
Press the OPERATE|STOP key to
activate or deactivate the unit.
During Normal Operation the
system will recirculate. When the
system is stopped the pump turns
off and water will not recirculate.
MENU Key
This key provides access to system
options and menus.
Cursor keys
These two cursor control keys are
used to select individual menu
items of the different menus. The
Y key moves the cursor one line
up, the y key one line down.
ENTER Key
Use this key to select a menu
item you have highlighted with
the cursor.
Display
– During Normal Operation the
display will show the water
quality reading – according to
the pre-selected measurement
unit options: (MO+cm or µS/cm)
The letter “C” indicates that the
water quality measurement is
automatically compensated
to 25°C.
– When the system is in Standby
Mode the display will show
“Standby”. The UV bulb will turn
on periodically to make certain the
TOC is kept at an acceptable level.
An automatic flush will take place
every 24 hours. When the system
is flushing the display shows the
following:
for 15 minutes every hour.
– The display will show the following
when the system is stopped:
System Inactive
Standby
Auto UF Flush
18.2 MO * cm c
14.32 20.02.01
6