Operating Manual Biowelder
®
Total Containment 45
Appendix
9.10 Error reports and Warning messages
The following tables list all error reports and warning messages which can
appear in the operator control.
Error report Possible cause Remedy
All runs blocked (X)
(X) = Error number
No. Error
0 Turning axis
1 Turning squeeze axis
2 Fixed squeeze axis
3 Cutting axis
4 Forward axis
5 Heating*
6 Fan
7 Placeholder
8 Placeholder
9 Cover lock
Run stopped by power fail
see Chapter 4.5 Blocked device
Follow the instructions on the user interface.
* The (5) Heating Error is triggered when the blade temperature has not reached the depyrogenisation temperature of < 400°C
Warning messages Possible cause Elimination
Please remove tube holder Tube holder inserted Tube holder removed
No tube holder inserted 1. No tube holder inserted
2. Contact surface of tube holder or the
spring contacts are dirty.
1. Insert tube holder set
2. Clean the contact surfaces of the tube
holders and those of the spring
contacts with a suitable cleansing agent
No matching tube was
found
No welding parameters available for the
selected type of tube and the inserted
tube holder set.
Was the right type of tube chosen?
Request new welding parameters from
Sartorius Stedim Biotech.
Only one tube holder
inserted
1. Only one tube holder is inserted
2. Only one tube holder is recognized.
1. Insert both tube holders.
2. Clean the contact surfaces of the tube
holders and those of the spring
contacts with a suitable cleansing agent
Tube holders do not match Tube holders with different color marking
were inserted.
Insert tube holders with the same color
marking.
Remove blade Blade has not yet been removed up to
now
Remove blade
Blade not inserted Blade not completely inserted to back
of holder
Insert blade
To Next Page
Loading...