The display will prompt you, the
operator to remove the sample
before the next sample can be
tested� Open the hood and carefully
remove this sample using tweezers,
and while the hood is open, add
the sample pan for the next sample
to be tested�
Caution
!
The sample is hot during and after
the test� Remove the sample with
care by using the tweezers provided
with the analyzer� Do not touch
any internal part of the heating
chamber or pan shield as they will
be very hot�
Press the Start|Stop key to begin the
next test using the same program�
Note
The analyzer balance must be calibrated
before putting the unit into routine
service� See the section on Calibrate Bal-
ance in this manual�
28
To Next Page
Loading...
