Setting Device Parameters (DEVICE)
Purpose
Device configuration, i.e. to meet
individual requirements by selecting
predefined menu parameters in the
Setup menu. Access to the menu may
be password-protected.
Features
Device parameters are combined into
the following groups (1st menu level):
– Password
– User ID
– Interface
– Drying report
– Clock
– Display contrast
– Acoustic signal
– Function of external switch
– Factory settings
The following parameters can
be displayed, entered and changed:
Password:
– Password for the device parameters,
drying programs and isoTEST functions
User ID:
– Text line with up to 20 characters for
GLP report header to identify user.
Interface:
– SBI operating mode
Simple record of analysis results for
PC or external printer, factory setting
for YDP03-0CE printer
Configurable: baud rate, number of
data bits, parity, stop bits, handshake
– xBPI operating mode
Function-oriented interface with
transparent data transfer
Network address: enter a number
from 0 to 31; factory setting: 0
Drying report:
– Select one of three display options for
the drying report:
– results only
– with GLP/drying parameters
– as per configuration: define
which parameters are to be output
(GLP head, program identifier,
header line 1, header line 2, heater
parameters, start criteria, shutoff
criteria, start weight, intermediate
result, end weight, end result and
name field).
– Clock:
Set time of day (hh.mm.ss; 24 hour clock)
and date (dd.mm.yy; in U.S. mode:
mm.dd.yy)
Display contrast:
– Set contrast/angle of display (enter a
number
from
0
to
4;
factory
setting:
2)
Acoustic
signal:
– Switch signal function on or off
Function
of
the
external
switch:
– Configure switch to activate one of
the following functions: Print key,
Enter key, CF key or bar code reader/
additional
keypad
Factory setting:
– Parameters: ‘
o’ is used to denote
factory settings (listed from page
17 onwards).
Preparation
Display existing device parameters
§ Select the Setup menu:
Use x or y to select SETUP in
the function line and confirm with
u
> SETUP is displayed:
§ Select Device parameters: Press the
y key and press u to confirm
If no password has been assigned, access
to the SETUP device parameters is
provided to all users without needing
to enter a password
If a password has been assigned:
> The password prompt is displayed
$
If access is password-protected:
Enter all of the password characters
using x and y and press
u to confirm
§ Confirm password and display device
parameters: Press u
> Device parameters are displayed:
14
To Next Page
Loading...
Need help?
General
