Purpose
The moisture analyzer has an interface
port for connecting an external printer,
a status display, a programmable
logic
controller (PLC) or a computer.
External printer:
Reports and settings may be output
to a printer.
Status display:
The status display shows the status
of the moisture analysis.
Programmable logic controller:
The PLC shows the status of the
moisture analysis and can activate
the function of the u key via
the digital input.
Computer:
Analyses and calculated values
can be sent to a computer for further
evaluation and documentation.
! Caution when using ready-made
RS-232 connector cable:
RS-232 cables purchased from other
manufacturers often have incorrect pin
assignments for use with Sartorius
weighing systems. Be sure to check the
pin assignments against the chart on
page 44 before connecting the cable and
disconnect any lines marked differently
(such as pin 6). Failure to do so may
damage (or completely ruin) your
weighing system and/or peripheral
device.
39
Features
Type of interface: Serial interface
Interface operating mode: Full duplex
Standard: RS-232
Transmission rate: 150; 300; 600; 1200; 2400; 4800; 9600; 19,200 baud
Number of data bits: 7, 8 bit
Parity: None, odd, even
Number of stop bits: 1 or 2 stop bits
Handshake mode: Software, hardware 1 character
Operating mode: SBI, xBPI
1
)
Network address
2
): 0, 1, 2, […], 30, 31
Data output format with SBI: 20 characters + CR LF
1
) xBPI operating mode always with 9600 baud, 8 bits, odd parity, 1 stop bit
2
) Network address is valid only in xBPI mode
Factory settings for SBI operating mode parameters:
Transmission rate: 1200 baud
Number of data bits 7 bits
Parity: Odd
Stop bits: 1 stop bit
Handshake: Hardware handshake after 1 character
Operating mode: SBI
Preparation
§ See pages 44 and 45 for the pin assignment chart and cabling diagram.
Interface Port
To Next Page
Loading...
