Sartorius MA150 - Password Management and Factory Reset; Entering and Changing User Passwords; Resetting Device Parameters to Factory Settings

Entering or Changing Password
– Password for access to the following
functions (up to 8 characters):
– SETUP device parameters
– Drying programs
– isoTEST setup
§ Display device parameters
(see “Display existing device parameters”
in “Preparation” section)
§ Record the password here:
Password =
If a password has been assigned but
forgotten:
$ Enter General Password (see Appendix)
$ Confirm password and display
device parameters: Press u
> Device parameters are displayed
(see above)
§ Select the “Password” device parameter
(if configured) and confirm: Press u
> Password: and any existing password is
displayed:
§
Enter new password:
Enter digits and letters (max. 8 charac-
ters) with x or y and confirm
with u
If the password field is blank,
no password has been assigned.
§ Confirm input:
Press u
§ Exit Setup menu:
Press the c key twice
15
Additional Functions
Print out parameter setting:
§ When device parameters are displayed:
Press the r key
> Printout (example)
Lines with more than 20 characters
are truncated
--------------------
14.07.2006 12:40
Model MA150Q-000230V
Ser. no. 18701636
Vers. no. 01-50-01
ID
--------------------
SETUP
DEVICE
--------------------
User ID
User ID:
Interface
SBI
Baud rate
1200 baud
Number of data bi
7 data bits
Parity
Odd
Number of stop bi
1 stopbit
Handshake mode
Hardware handshake
after 1 char
Drying report
with GLP/drying
parameters
Clock
Acoustic signal
On
Display contrast
2
External T function
Print button
--------------------
Reset device parameters to factory
settings:
§ Select the Setup menu:
Use the x or y keys to select
SETUP in the function line and press
u to confirm
> SETUP is displayed:
§ Select Device parameters:
Press the y key and press u
to confirm
$ If access is password-protected:
enter the password as described above
§ Confirm password and display device
parameters: Press u
> Device parameters are displayed:
§ Select Factory settings:
Press the y key 4 times
§ Confirm factory settings:
Press u
$ To cancel operation at this point:
Press c
§ Select Yes and confirm.
Press y and
press u
§ Exit Setup menu:
Press the c key 3 times