Data Input Format
Remote Operation (Computer)
The computer connected on the data port can send commands to the weighing system
to control functions.
These are control commands and use different formats.
Control commands have up to 26 characters. Transmission of these characters is
based on the setup configuration for data transmission.
Control command formats
Format 1: ESC ! CR LF
Format 2: ESC ! # _ CR LF
Format 3: ESC ! (alphanumeric character) _ CR LF
Format 4: ESC ! # (alphanumeric character) _ CR LF
Format 1 (e.g. ESC K)
! Meaning
K Weighing mode 1
L Weighing mode 2
M Weighing mode 3
N Weighing mode 4
O Block keypad
P Print
Q Beep (acoustic signal)
R Unblock keypad
S Restart
Format 2 (e.g. ESC x1_)
!# Meaning
acc Only SBI commands, no
print output
acp SBI with print output
ars Read status
kF1 u key
kF2 x key
kF3 y key
kF11 c key
x1 Output device type
x2 Output serial number
x3 Output weighing encoder
software version
x4 Output operating unit
software version
x5 Output (GLP) ident. no.
Format 3:
! Meaning
t Alphanumeric input (max. number
of characters depends on display)
Format 4:
!# Meaning
z5 Input (GLP) ident. no.
(max. 14 characters)
42
ESC: Escape
!: Alphanumeric character
#: Digit
_: Underline (ASCII 95)
CR: Carriage return (optional)
LF: Line feed (optional)
Digital Input
(Programmable Logic Controller)
The universal switch input (pin 15) is used
for remote operation. The Enter key must
be configured in the menu (
Device
Setup Ext. switch
) .
Barcode Scanner/Additional Keypad
A bar code scanner or additonal keypad
can be connected to pin 15 and pin 19
of the D-SUB 25 connector (see pin assign-
ment chart). Barcode scanner/additional
keypad must be configured in the menu
(
Device Setup Ext. switch).
The key assignment of the additional
keypad is as follows:
Additional keypad keys Meaning
F6 x key
F7 y key
F8 u key
F10 c
key
F11 r
key
Return u
key
Backspace c
key
Cursor up x key
Cursor down y key
Cursor right u key
Esc c key
Print r
key
To Next Page
Loading...
