Sartorius MA37 - USB port

30
System Settings (Setup Menu)
Operating Instructions Moisture Analyzer MA37
sorted by date, Timeout standby temp.
Timeout Standby Temp.
2
1
3
Time [h]
The timeout for the standby temperature can be set here.
t To set the time, select t, enter the desired time and confirm with l (entry in
hours from 1 h to 24 h).
USB port
USB port
Device / Protocol
RS232 Configuration
Decimal separator
Keyboard emulation
The settings for the data transfer to a peripheral device (such as a PC or printer)
can be defined here.
Depending on the cable and peripheral device connected to the moisture analyzer,
various options are available in the menu. The moisture analyzer automatically
detects the type of connection.
There are several ways to connect the device via USB:
1) Connection to a PC via USB Cable (Mini-B to USB A)
Device / Protocol
PC - SBI
PC spreadsheet format
PC text format
Off
Under Device/Protocol:
t Select the data format for the transfer to the PC.
– PC - SBI: Driver for PC required (CDC Virtual Com Port). The data is sent
via SBI protocol using a virtual serial interface. Additional information can
be found in Chapter “USB Interface”, section “Direct Transfer of Data (PC)”.
– PC spreadsheet format: The analyzer transmits the data via keyboard
command (keyboard emulation) to the currently opened application on the
PC in spreadsheet format.
– PC text format: The analyzer transmits the data via keyboard command
(keyboard emulation) to the currently opened application on the PC in text
format.
– Off: Data transmission is deactivated.
Under Decimal separator (also available when “PC spreadsheet format” has been
Mini-B
PC-SBI
PC spreadsheet format
PC text format
Off
Printer YDP20-0CE
USB-RS 232 SBI
Off
Printer YDP30,
YDP40
Off
Type-A
Mini-A Type-B
Mini-A
RS 232
9-pin
Sartorius order no.:
YCC04-D09
Sartorius order no.:
YCC03-D09
USB Host
(Master)
1)
2)
3)
USB Device
(Slave)
Serial device
with 9-pin
SUB-D plug
Printer equipment
supplied