Signals
Signals
Touch signals
Acoustic signal
Status light
The key tones, acoustic signals, and process status light can be switched on
and off here.
The following settings are available for each signal:
– On: The signal is activated.
– Off: The signal is deactivated.
Display Brightness
Display brightness
Eco mode
Medium
Bright
The brightness of the display can be set here.
The following brightness levels are available:
– Bright
– Medium
– Eco mode: Energy-saving mode (factory setting): The brightness is reduced
after 2 min. of inactivity. To reactivate the normal brightness: Touch the screen
or open the heating module. During measurement and during the results
display, eco mode is deactivated.
Identifiers
Identifier
Device ID
Batch ID function
Sample ID function
The identifiers for the printout can be defined here.
– The Device ID identifier is entered here once. The device ID can be a maximum
of 14 characters long.
– The Batch ID and Sample ID functions can be activated here. The user must
then enter the batch and sample IDs before each measurement routine. Batch
and sample IDs cannot exceed 20 characters.
Under Device ID:
The device identifier (ID) is printed on the GLP report in the header.
t To set the device ID, select Device ID, enter the desired device ID and
confirm with l.
Under Batch ID function:
The batch ID (L ID) is queried once at the beginning of the measurement routine.
t If you wish to print the batch ID, activate this option.
Under Sample ID function:
The sampleID (S ID) is queried once at the beginning of the measurement routine.
t If you wish to print the sample ID, activate this option.
To enter and delete numbers and text, e.g., for the sample ID,
see “Entering Text and Characters” on page 24.
To Next Page
Loading...
