Sartorius PR 5210 Series - Page 49

PR 5210 Operating Manual Profibus Interface
Sartorius 49
6.1.6.4 Reset transmitter to default (factory) data
Master
Transmitter
Set parameter P20 to 1 (Start Cal)
(method see chapter 6.1.6.1)
The CAL switch is tested, if the switch is not in the
'locked' position, the procedure is started.
Set parameter P20 to 2 (default = factory
data)
(method see chapter 6.1.6.1)
Default data are taken as calibration data.
All ADU data will be reset. See chapter 4.7
Set parameter P20 to 3 (SaveAndExit)
(method see chapter 6.1.6.1)
Data are stored in the non-volatile EAROM