Sartorius SIWABBP - Page 19

Signum1-2-3
Settings
19
Operating Menu
= Setting/Function available for Signum
®
1 and 2 only
= Setting/Function available for Signum
®
2 and 3 only
* Factory setting
Menu
appl Application programs
appl1
1
)
W / weigh. Basic weighing function
3.5. Minimum load for automatic taring and automatic printing
3.5.1 * 1 digit
3.5.2 2 digits
3.5.3 5 digits
3.5.4 10 digits
3.5.5 20 digits
3.5.6 50 digits
3.5.7 100 digits
3.5.8 200 digits
3.5.9 500 digits
3.5.10 1000 digits
3. 7. Automatic taring: first weight tared
3.7.1 * Off
3.7.2 On
3. 25. Tare function
3.25.1 Can add a preset tare if tare value is available; however no tare function possible
3.25.2 When a preset tare is entered, the tare value is deleted; however tare function activation is possible
9. 1. Factory settings for all application programs
9.1.1 * Yes
9.1.2 * No
Z / count. Counting
3.5. Minimum load for automatic taring and automatic printing
2
)
3.5.1 * 1 digit
3.5.2 2 digits
3.5.3 5 digits
3.5.4 10 digits
3.5.5 20 digits
3.5.6 50 digits
3.5.7 100 digits
3.5.8 200 digits
3.5.9 500 digits
3.5.10 1000 digits
3.6. Minimum load for initialization
3.6.1 * 1 digit
3.6.2 2 digits
3.6.3 5 digits
3.6.4 10 digits
3.6.5 20 digits
3.6.6 50 digits
3.6.7 100 digits
3.6.8 200 digits
3.6.9 500 digits
3.6.10 1000 digits
3.7. Automatic taring: first weight tared
3.7.1 * Off
3.7.2 On
3.8. Automatic start of applications when you switch on the device with most recently saved application data
2
)
3.8.1 Automatic (On)
3.8.2 * Manual (Off)
3.9. Resolution for calculation of reference value
3.9.1 * Display accuracy
3.9.2 Display accuracy + 1 decimal place
3.9.3 Display accuracy + 2 decimal places
3.9.4 Internal resolution
3.11. Parameter for saving weight values
3.11.1 * With stability
3.11.2 With increased stability
3.12. Average piece weight updating
3.12.1 Off
3.12.3 * Automatic
3.13. Reference weighing instrument
3.13.1 * No weighing platform selected
3.13.2 Weighing platform WP 1
3.13.3 Weighing platform WP 2
3.25. Tare function
2
)
3.25.1* Can add a preset tare if tare value is available; however no tare function possible
3.25.2 When a preset tare is entered, the tare value is deleted; however tare function activation is possible
9.1. Factory settings for all application programs
2
)
9.1.1 Yes
9.1.2 No
1
) Setup level for Signum
®
3 only
2
) For Signum
®
2 only