Satel Versa Seris - Programming the Address Without Entering the Service Mode; Identification of Devices Connected to the Bus; Starting the Identification Function from Keypad

SATEL VERSA 25
5. Press the key to finish the function. The keypad will be restarted. The function will
be finished automatically after 2 minutes since it was launched.
5.11.2 Programming the address without entering the service mode
This way of address programming is useful when the keypad operation is blocked and
starting the service mode is impossible.
1. Power off the keypad.
2. Disconnect cables from the keypad CLK and DTA terminals.
3. Short the CLK and DTA keypad terminals.
4. Power on the keypad. The LEDs designated with icons will start blinking in the keypads
and information on the current address will be presented by means of:
LCD: displayed message,
LED: rapid blinking of the LED designated with the number corresponding to the keypad
address – see Fig. 27.
5. Press the key with the number corresponding to the new address. The address change
will be confirmed by four short beeps followed by a long one. Pressing
allow to
change the address again (the keypad restart will follow and information on the current
address will be displayed again).
6. Power off the keypad.
7. Open the CLK and DTA keypad terminals.
8. Connect cables properly to the CLK and DTA keypad terminals.
9. Power on the keypad.
5.12 Identification of devices connected to the bus
Devices connected to the communication bus will not be properly supported, unless they
have been identified by the control panel. Identification of the devices is required after the
first start-up of the control panel and then each time after a new device is added or the
address was changed in a device supported by the control panel.
Disconnecting an identified device from the communication bus will trigger the tamper
alarm.
5.12.1 Starting the identification function from keypad
1. Enter the service code (by default 12345) and press the key.
2. Press in turn the
keys. The service mode will start.
3. Press in turn the
keys. The IDENTIFICATION function will start.
Three short beeps will indicate that identification has been completed and information on
the identified devices will be presented (on the display in the LCD keypad and by means
of LEDs in the LED keypad).
4. Press the key to quit the function.
If the identification is terminated by two long beeps, this means that a wrong address
is set in the device connected to the communication bus (unsuitable for this type of
device or the same in at least two devices). The displayed message (in the LCD
keypad) or the blinking LED corresponding to the device address (in the LED keypad)
will be helpful in diagnosing the problem. Press , set the correct address in the
device, and then restart the IDENTIFICATION function.