Satel Versa Seris - Default Chapter; Table of Contents

2 VERSA SATEL
CONTENTS
1. Introduction.....................................................................................................................4
2. Features...........................................................................................................................4
3. Keypads...........................................................................................................................6
3.1 Keypads features.......................................................................................................6
4. Expansion modules........................................................................................................7
5. System installation .........................................................................................................7
5.1 Installation plan..........................................................................................................7
5.2 Estimation of the system current consumption ..........................................................8
5.3 Cabling ......................................................................................................................8
5.4 Installation of control panel mainboard ......................................................................8
5.4.1 Description of the mainboards ............................................................................9
5.5 Connecting devices to the communication bus........................................................11
5.5.1 Connecting hardwired keypads ........................................................................11
5.5.2 Connecting Ethernet module ............................................................................12
5.5.3 Connecting 433 MHz keyfobs receiver expansion module ...............................13
5.5.4 Connecting 433 MHz wireless system controller ..............................................13
5.5.5 Connecting ABAX wireless system controller ...................................................14
5.5.6 Connecting the hardwired zone expanders ......................................................15
5.5.7 Connecting the hardwired output expander ......................................................16
5.5.8 Connecting proximity card arm/disarm devices ................................................17
5.5.9 Connecting voice module / voice synthesizer expander ...................................18
5.6 Connecting the detectors.........................................................................................18
5.6.1 End-of-line resistors..........................................................................................19
5.7 Connecting the sirens ..............................................................................................19
5.8 Connecting the radio monitoring transmitter ............................................................20
5.9 Connecting the analog telephone line......................................................................21
5.10 Connecting the power supply and starting the control panel ...................................22
5.10.1 Main power supply............................................................................................22
5.10.2 Backup power supply .......................................................................................22
5.10.3 Control panel power-up / start-up procedure ....................................................23
5.10.4 Emergency procedure of the control panel start-up..........................................23
5.10.5 First steps after starting-up the control panel....................................................23
5.11 Programming addresses for the hardwired keypads................................................24
5.11.1 Programming the address by means of the service function ............................24
5.11.2 Programming the address without entering the service mode ..........................25
5.12 Identification of devices connected to the bus .........................................................25
5.12.1 Starting the identification function from keypad ................................................25
5.12.2 Starting the identification function from DloadX program..................................26
5.13 Connecting the computer to the control panel .........................................................26
5.14 Installation of ABAX wireless devices ......................................................................26
5.14.1 Adding new ABAX wireless devices .................................................................26
5.14.2 Removing ABAX wireless devices....................................................................28
5.15 Installation of 433 MHz wireless detectors...............................................................28
5.15.1 Adding new 433 MHz wireless detectors..........................................................28
5.15.2 Removing 433 MHz wireless detectors ............................................................29
6. Numeration of zones and outputs in the system .......................................................30
6.1 Numeration of zones................................................................................................30