Special Notes 1. Auto-smoothing (when enabled) is only effective if the character
expansion rate is at least (3) times in each direction.
2. Characters may be enlarged through the use of the <ESC>L
Character Expansion command (see Page 4-23).
3. Character spacing may be altered through the use of the <ESC>A
Character Pitch command (see Page 4-26).
4. A font must be defined for each field to be printed. There is no
default font.
5. The proportionally spaced fonts XU, XS, XM, XL and XB can be
printed with fixed spacing using the <ESC>PS Proportional Space
command.
Section 4. Programming Reference
SATOCL Series Printers9001035 Rev. EPage 4-39
To Next Page
Loading...
