UNPACKING AND PARTS IDENTIFICATION
Consider the following when unpacking the printer:
• The box should stay right-side up.
• Lift the printer out of the box carefully.
• Remove the plastic covering from the printer.
• For the CL4XX printers, remove the Front Access Door from its protective
bag and attach it to the printer.
• Remove the accessory items from their protective containers.
• If the printer has been stored in a cold environment, allow it to reach room
temperature before powering it on.
• Set the printer on a solid, flat surface. Inspect the shipping container and
printer for any signs of damage that may have occurred during shipping.
NOTE: The following illustrations are representative only. Your printer may not be
packed exactly as shown here, but the unpacking steps are similar.
CL4XX Packaging CL6XX Packaging
Section 2. Installation and Configuration
Page 2-29001035 Rev. ESATOCL SeriesPrinters
To Next Page
Loading...
