<ESC>A<ESC>R<ESC>V0200<ESC>H0100<ESC>L0202<ESC>P02<ESC>XB1E<ESC>Q1<ESC>Z
COMMAND DEFAULT SETTINGS
There are some types of commands that must have a value specified before a label
can be printed. If the data stream does not contain these commands, a “default” value
is assumed. The commands and the corresponding default values are:
COMMAND DEFAULT NOTE
Print Rotation 0° (1)
Vertical Reference Point 0 (1)
Horizontal Reference Point 0 (1)
Character Pitch 2 (1)
Base Reference Point H=0, V=0 (2)
Character Expansion 1 (1)
Print Darkness 2 (1)
Print Speed CL6XX 6 ips (2)
Print Speed CL4XX 4 ips (2)
Proportional Spacing Enabled (1)
Cutter Command Disabled (1)
NOTES:
(1) The settings for these commands will revert to the default value when the printer
receives an <ESC>Z or an <ESC>*.
(2) The values transmitted with these commands will remain in effect until a new
command is received.
E
E
H=200
V=800
Base
Ref
Point
Base
Ref
Point
H=100
V=200
Label
Feed
Direction
“R”
“%1”
Section 4. Programming Reference
SATOCL Series Printers9001035 Rev. EPage 4-9
To Next Page
Loading...
