SWITCHES AND SENSORS CL608 and CL612
Ribbon End Sensor: This sensor is a motion detector that signals the printer
when the ribbon supply is turning.
Head Open Switch: When the print head is opened, this switch is activated
and the printer will stop printing.
Label Sensor Unit: This sensor unit contains two types of sensors, one for
label gap and one for Eye-Mark sensing. The label
sensors on the CL608 and CL612 are fixed and are
not adjustable.
Ribbon
Motion
Sensor
Label Sensor
Unit
0.33" (9 mm) Eye-Mark Sensor
1.0" (25 mm) to 3.5" (90 mm)
Label Gap Sensor
Min. Inter-Label Gap
0.12" (3 mm)
Backing
Paper Inside
Edge
Label Inside Edge
Label
Feed
Direction
Miminum Eye-Mark Size
.12 in (3 mm) W x .24 in. (6 mm) L
CL608 and CL612 Label Sensor Positioning
Section 2. Installation and Configuration
Page 2-18 9001035 Rev. D SATO CL Series Printers
To Next Page
Loading...
