SATO CL408 - CL408 and CL412

ERROR SIGNALS CL408 and CL412
STATUS
LED
(1)
LCD
MESSAGE
AUDIBLE
BEEP
ERROR CONDITION TO CLEAR
Red Machine Error 1 Long Machine Error Cycle power on/off
Red EEPROM Error 1 Long EEPROM Read/Write Cycle power on/off
Red Head Error 1 Long Head Cycle power on/off
Red Sensor Error 3 Short Sensor Open/Close Head
Red Blinking Card R/W Error 1 Long Memory Card Read/Write Cycle power on/off
Red Blinking Card Low Battery 1 Long Memory Card Battery Low Cycle power on/off
Red Blinking Head Open 3 Short Head Open Close head lever
Red Blinking Cover Open 3 Short Front/Top Door Open Close Doors
Red Blinking Parity Error 3 Short RS232 Parity Error Cycle power on/off
Red Blinking Overrun Error 3 Short RS232 Overrun Error Cycle power on/off
Red Blinking Framing Error 3 Short RS232 Framing Error Cycle power on/off
Red Blinking Buffer Over 3 Short Buffer Overflow Cycle power on/off
Red Blinking Paper End 3 Short Label End Open/Close Head
Red Blinking Ribbon End 3 Short Ribbon End Open/Close Head
Red Blinking Cutter Error 3 Short Cutter Malfunction Open/Close Head
(1) The Status indicator is a two-color (red and green) LED.
Section 6. Troubleshooting
SATOCLSeriesPrinters9001035Rev.EPage6-5