1. Do not combine this command and the <ESC>% rotate command
(see Page 4-68) in the same data stream.
2. A custom graphic is not affected by this command. Therefore,
always design and locate your graphic image to print in the
appropriate orientation.
3. See Section 4, Rotated Fields, Page 4-7, for more information.
4. The specified values are valid until another Rotate (<ESC>R)
command is received.
5. Receipt of a Stop Print (<ESC>Z) command will reset the setting to
the default value.
Section 4. Programming Reference
SATOCL Series Printers9001035 Rev. EPage 4-71
To Next Page
Loading...
