SATO CL408e - Print Head Position Alignment

Page 5-7
Section 5. Mechanical Adjustments
SATO CL408e/CL412e Service Manual
PN 9001078
Rev. A
5.5 Print Head Position Alignment
STEP PROCEDURE
1. Loosen the center and right screw on the ribbon adjustment plate. Print a user
test pattern (Section 8.9). Realign the right side of print head by prying adjust
plate forward or backward with a flat blade screwdriver. Refer to illustrations
and note adjustment marks. Figs. 5-6
2. Tighten the screws.
MINOR ADJUSTMENT
To adjust the print head alignment and make print quality consistent across
label, perform the following steps:
Required Equipment:  10mm Open End Wrench
 #2 Pozidrv Screwdriver
SCREWS
ADJUSTMENT
MARKS
RIBBON ADJUST
PLATE
Figs. 5-6