9. All commands can be used with this command. However, the
following commands may cause improper results if they are
included in the middle of the data stream.
<ESC>A Start Code <ESC>& Store Form Overlay
<ESC>Z Stop Code <ESC>T Store Custom Characters
<ESC>C Repeat Lbel <ESC>YS Store Format
<ESC>O Partial Edit <ESC>/N Store Field
<ESC>A3 Base Reference Point <ESC>GI Store Custom Graphics
<ESC>CS Print Speed <ESC>PI Store PCX Graphics
<ESC>#E Print Darkness <ESC>GT Store BMP Graphic
<ESC>@ Offline <ESC>TE Store Bitmapped Font
<ESC>ID Store Job ID <ESC>CC Memory Area Select
<ESC>* Clear Print Job/Mem <ESC>BJF Initialize Exp. Memory
<ESC>BT Variable Ratio Bar Codes <ESC>EX Expand Memory Area
<ESC>BW Expanded Bar Codes <ESC>~ Cutter Command
Page 5-92 PN 9001074 Preliminary SATO CL Series “e” Printers
Section 5. Programming Reference
To Next Page
Loading...
