Printer Setting
Command Structure <ESC>PCaa,a,b,c,d,e,f,g,h,h,i,j,k,l,m,n,o,p,q,r,s,t,u,v,w,x,y,z
<ESC>PCaa,bb
aa = Setting to be changed (01 to 26). Only
revelant setting can be changed. To change
multiple settings, must be set to “F”.
SETTING
(ASCII)
COMMAND
PARAMETER
ASCII
VALUE
DESCRIPTION
01 a 0 Reserved
02 b 0 Reserved
03 c 0 Print Speed, 2 ips (50 mm/s)
03 1 Print Speed, 3 ips (75 mm/s)
03 2 Print Speed, 4 ips (100 mm/s)
03 3 Print Speed, 5 ips (125 mm/s)
03 4 Print Speed, 6 ips (150 mm/s)
03 5 Print Speed, 8 ips (200 mm/s)
03 6 Print Speed, 10 ips (250 mm/s)
04 d 0 Reserved
05 e 0 Cutter Mode, Backfeed after print
05 1 Cutter Mode, Backfeed before print
05 2 Cutter Mode, no Backfeed
06 f 0 Dispense Mode, Backfeed after print
06 1 Dispense Mode, Backfeed before print
07 g 0 Reserved
08 h A Print Darkness Range A
08 B Print Darkness Range B
08 C Print Darkness Range C
08 D Print Darkness Range D
08 E Print Darkness Range E
08 F Print Darkness Range F
09 i 1 Print Darkness Level 1
09 2 Print Darkness Level 2
09 3 Print Darkness Level 3
SATO CL Series “e” Printers 9001074 Preliminary Page 5-117
Section 5. Programming Reference
To Next Page
Loading...
