SATO CL412e - Page 193

Input to Printer <ESC>A
<ESC> PC26,0
<ESC>Z
Printer Output There is no printer output as a result of this command. This command
enables the buzzer.
Special Notes 1. All command setting values must be in ASCII format.
2. These settings are stored in EEPROM and will remain valid until
receipt of another <ESC>PC command.
3. All positions in this command must be separated by a comma. If
the parameter. To change multiple settings, the correct number of
commas must be placed in the command, i.e. to change the label
gap sensor to reflective (eye-mark), the command would be:
<ESC>PC,,,,,,,,,0,,,,,,,,,,,,,,,,,.
4. If only one setting is to be changed, the “aa” parameter must be
an “F”.
SATO CL Series “e” Printers 9001074 Preliminary Page 5-119
Section 5. Programming Reference