SATO CL412e - Page 6

Clear Non-Standard Protocol Codes ................3-
Download User Defined Protocol Codes ..............3-
Hex Dump Mode..........................3-
SECTION 4. CLEANING AND MAINTENANCE
Introduction ..............................4-
Procedures, CL608e and CL612e ...................4-
Adjusting the Print Quality ....................4-
Darkness ............................4-
Print Speed...........................4-
Cleaning the Print Head, Platen and Rollers............4-
Replacing the Print Head .....................4-
Cleaning the Sensors .......................4-
Replacing the Fuse.........................4-
Procedures, CL408e and CL412e ...................4-
Adjusting the Print Quality ....................4-
Darkness ............................4-
Speed .............................4-
Cleaning the Print Head and Platen ................4-
Replacing the Print Head .....................4-
Cleaning the Sensors .......................4-
Replacing the Fuse.........................4-
SECTION 5. PROGRAMMING
Introduction .............................5-1
The SATO CL Programming Language ................5-1
Selecting Protocol Control Codes ..................5-2
Using Basic..............................5-2
The Print Area ............................5-4
Rotated Fields ............................5-8
Command Default Settings .....................5-9
Command Codes ..........................5-10
Bar Codes ............................5-11
Bar Codes, Expansion ......................5-16
Bar Codes, Variable Ratio ....................5-17
Base Reference Point ......................5-19
Characters, Custom Designed ..................5-21
Character Expansion ......................5-23
Character, Fixed Spacing ....................5-25
Character Pitch .........................5-26
Character, Proportional Spacing ................5-28
Clear Print Job(s) and Memory .................5-29
Page - iv PN 9001074 Preliminary SATO CL “e” Series Printers
Preface